CAT injector

CAT injector	Bore Dia	Outer DIa	Width	Size
CAT 254-4339 injector	35 mm	2150 lbf	130 mm	1080 lbf
CAT 10R-7222 injector	9/16 in	CT-1000-K26, SAE841	3/4 in	RoHS, REACH, DRC Conflice Free
CAT 387-9433 injector	0.9375 in	1420 lbf	Cast Iron - Nickel Protection	PF3/4
CAT 268-1835 injector	1.2500 in	2150 lbf	3.9375 in	1080 lbf
CAT 387-9428 injector	1.3750 in	3.6250 in	PTFE	0.7500 in
CAT 268-9577 injector	2.9375 in	3.3800 in	10.8300 in	Non-Expansion Bearing (Fixed)
CAT 387-9426 injector	-	-	-	-
CAT 463-1678 injector	1.1875 in	4410 lbf	3.2500 in	2540 lbf
CAT 20R-4562 injector	3-15/16 in	Set Screw	30 in	2-1/2 in
CAT 4631678 injector	1.0000 in	1-5/8 in	Round	1-1/8 in
CAT 10R-7652 injector	2.7500 in	3.1300 in	10.4400 in	Non-Expansion Bearing (Fixed)
CAT 10R7649 injector	8 mm	24.5 (250) Static 49 (500)	10 mm	0.4 m/s

Page3/10

CAT injector : A Complete Guide to Buying

1. Do you have to program new injectors?

Do you have to program new injectors?

1、May 6, 2020 — You replace the component, but you need to introduce the trim code to the ECM. How can I do that correctly so that the engine runs like a top?
2、Nov 30, 2021 — Do You Need To Program New Injectors? CR injector calibration is primarily concerned with coding, since new and reconditioned injectors alike ...
3、After biting the bullet and ordering all new genuine injectors from FCP, I was on the website looking ... -Do you have to use ISTA P for the programming?
4、Nov 17, 2016 — Does anyone have experience or know of someone or can point me in the right direction for ... I dont think you need to code n55 injectors.
5、Non start – In newer systems if you do not code in the injectors the ... also have a new calibration code, which is typically affixed to the injector as a ...
6、Jun 26, 2012 — Fitting some new injectors means we have to tell the ECU what we have done so that it can make the appropriate calculation to allow the ...
7、... 6.4L Fuel Injectors · INstallation Instructions. Installation Videos. Duramax Flow Rate (Injector Quantity Adjustment) Programming with Autel Scan Tool ...SMP Knowledge Center · InstallationSpotlight · May 1, 2005
8、Sep 1, 2018 — The new injector code needs to be programmed into the ECM. Unless you have the dealer's WiTECH unit for programming the vehicle, you can't do it ...
9、Mar 9, 2018 — When you install new fuel injectors on your BMW N54 engine, you will need to enter each new injector value into the PCM.
10、Mar 16, 2018 — this should be taken seriously. in extreme conditions, fuel can fill a cylinder and prevent compression, ruining the engine. 4. poor fuel ...