CAT injector

CAT injector	Bore Dia	Outer DIa	Width	Size
CAT 387-9427 injector	-	-	-	-
CAT 10R-7225 injector	2.9375 in	3.0000 in	13.5800 in	Non-Expansion Bearing (Fixed)
CAT 387-9430 injector	2.5000 in	2.9000 in	10.2500 in	Non-Expansion Bearing (Fixed)
CAT 328-2585 injector	17 mm	2150 lbf	90 mm	1080 lbf
CAT 387-9428 injector	SAF311, SAF611	Steel	22311E, 22311EK	1
CAT 241-3239 injector	3.1875 in	3.7500 in	12.3000 in	Non-Expansion Bearing (Fixed)
CAT 238-8901 injector	4.0000 in	Hex	2.2500 in	2-12
CAT 243-4502 injector	2 in	RoHS, REACH, DRC Conflice Free	6-1/2 in	9001:2008 & 14001:2004
CAT 269-1839 injector	3.4375 in	3.4100 in	13.5000 in	Expansion Bearing (Floating)
CAT 328-2586 injector	1.2500 in	Dual Lip with Slinger	2.4375 in	4-59/64 in
CAT 217-2570 injector	Pillow Block Bearings	0.0	N/A	18.614
CAT 10R-7224 injector	2.4375 in	Double V-Lock	5.3800 in	Non-Expansion Bearing (Fixed)

Page1/10

CAT injector : A Complete Guide to Buying

1. Do you have to program new injectors?

Do you have to program new injectors?

1、May 6, 2020 — You replace the component, but you need to introduce the trim code to the ECM. How can I do that correctly so that the engine runs like a top?
2、Nov 30, 2021 — Do You Need To Program New Injectors? CR injector calibration is primarily concerned with coding, since new and reconditioned injectors alike ...
3、After biting the bullet and ordering all new genuine injectors from FCP, I was on the website looking ... -Do you have to use ISTA P for the programming?
4、Nov 17, 2016 — Does anyone have experience or know of someone or can point me in the right direction for ... I dont think you need to code n55 injectors.
5、Non start – In newer systems if you do not code in the injectors the ... also have a new calibration code, which is typically affixed to the injector as a ...
6、Jun 26, 2012 — Fitting some new injectors means we have to tell the ECU what we have done so that it can make the appropriate calculation to allow the ...
7、... 6.4L Fuel Injectors · INstallation Instructions. Installation Videos. Duramax Flow Rate (Injector Quantity Adjustment) Programming with Autel Scan Tool ...SMP Knowledge Center · InstallationSpotlight · May 1, 2005
8、Sep 1, 2018 — The new injector code needs to be programmed into the ECM. Unless you have the dealer's WiTECH unit for programming the vehicle, you can't do it ...
9、Mar 9, 2018 — When you install new fuel injectors on your BMW N54 engine, you will need to enter each new injector value into the PCM.
10、Mar 16, 2018 — this should be taken seriously. in extreme conditions, fuel can fill a cylinder and prevent compression, ruining the engine. 4. poor fuel ...